News

Home > News > Content
The Pros And Cons Of New Zealand Pine Finger Joint Board
Dec 01, 2016

The Pros And Cons Of New Zealand Pine Finger Joint Board

 

  • The Pros of New Zealand Pine Finger Joint Board

 

1. In order that we have a comprehensive use of wood to reduce the waste of wood, we should be in accordance with the requirements of the combination, the specification of wood cutting,mixed use the pros and cons of wood.

2.  In the procession of pro-ducting, strict screening of materials, let New Zealand Pine is capable of producing good, avoid the defects of wood.

3. To retain the natural texture of wood, to make the appearance more beautiful.

4.  The integrated timber raw material after fully dry and a series of related operations, in the latter part of the production process of wood moisture content is unified, so that products are not prone to cracking and deformation.

5.  The integrated material in tensile and compressive properties were better than solid wood.

6.  According to different requirement, from different shapes of New Zealand Pine, do some shaping work. They can extend the degree of gradient, I-shaped, square hollow section glulam.

7.  compared with the solid wood, wood material yield is low, the cost of the product is relatively high.

  • The Cons of New Zealand Pine Finger Joint Board

1. Too many surface cracks, internal cracks.

2. End cracks, cracked, the minimum is not more than 50MM. Also not allowed.

3. Gap. In addition to the circumstances mentioned in the RW by WWPA, the gap is not allowed to occur.

4. Blue -stainIf there is a certain amount of mildew in the surface, but will not cause overall radiate pine blue, it's within acceptable limits.

5. The resin content is too much, cause the wood finishing difficult.

6. Dry spot. But if the wood surface planing to 2MM, if there is no obvious scar;is acceptable.

7. Each package, the short size of the plate, according to the volume of not more than 5%.





Copyright © E&R Wood Co,.Ltd All